To see if I'm on the air right now click here

Tuesday, September 29, 2009

A 1928 Hartley

After seeing my 1934 transmitter a friend asked if I was doing anything special for the Bruce Kelley Memorial 1929 QSO Party coming up in December. Last year I put my TNT transmitter and SW3 on the air. This year it might be interesting to try a Hartley oscillator.

As ham radio approached January 1, 1929, and the more rigorous standards, the ARRL encouraged hams to improve their stations. One improved transmitter design was a single tube Hartley oscillator described by Ross Hull in the August 1928 issue of QST. Bruce Howes, W1UJR, covers this design on his web site here.

I've been searching through my junque box looking for the parts I need. The first step was a parts list and an enlarged scan/photo of the transmitter. After picking thr
ough multiple boxes and peanut butter jars I've lots of possibilities. Now it's a matter of sorting through what I have for the parts that match the original design.

Sunday, September 27, 2009

Camping and Picnic Table QRP

This last weekend we planned a campout at Frontenac State Park. We've picniced there several times but have never camped over night. No camping trip packing list is complete without my K1. (This time we did forget the blankets and pillows but the K1 was loaded.)

I ended up getting several chances to ham. After a quick listen on 20 and discovering the CQ WW RTTY contest in full swing I moved to 30 mtrs for the weekend. The antenna was a 45' endfed wire (1/2 length wave on 30 mtrs) in a tree next to the campsite. It was approximately broadside to the NNE but did a great job into the northeast US. Between Saturday and Sunday I worked W3XAF (MD), KB3TJS (MD), W0IMD (CO), AA3TH (PA), WA1IIE (ME) and KD3DK (PA).

Tuesday, September 22, 2009

More 1934 Transmitter

Remember the safety problem with my 1934 transmitter? One of the phone plugs is for metering and the other is for the key. If, in the heat of the moment, I get the two mixed up and plug the key into a B+ metering jack, I'll have over 300 volts on the key.

To protect myself I tied a length of string and a plastic cable clamp to the key phone plug (any lump of plastic would work). After the key is plugged in I slide the cable clamp under the front edge of the transmitter. The string is short enough that the plug can not be removed without getting the clamp out from under the transmitter.

Wednesday, September 16, 2009

A 1934 transmitter - On the Air

Yesterday I set up my 1934 transmitter up with my NC101X and tried the pair out on 80 meters using my endfed 105' inverted "L" antenna only about 10'-20' off the ground. The station worked fine.

At 21:45 I had a nice QSO on 3570 with NG9D in Plainfield, IL. Lynn's signal varied from 589 to 599+. He reported that my 589 signal sounded fine/stable.

Also shown in the picture is my iambic keyer set up to key older tube rigs.

Sunday, September 13, 2009

More 1934 transmitter - It Works!

I've finished wiring my 1934 transmitter, powered it up and it works! With about 300 volts on the plates of the 46s and the 47 it loads to 15-20 watts input and 7-10 watts output. It sounds great also.

One change I made from the Bill Orr design is to connect the 47 screen to regulated 150V rather than a resistor network off of B+.

This transmitter is not without some personality, though. Only the amplifier stage is keyed so the oscillator stage runs continuously. On key up any energy from the oscillator that makes it to the antenna will be heard as a faint back wave. We'll see if this is objectionable. The second personality trait is, unfortunately, pretty nasty. When using the rig, one phone plug is for metering and a second is for the key. If in the heat of the moment I get the two mixed up and plug the key into a metering jack I'll have over 300 volts on my key. To make matters even worse, keying the metering/B+ line works so I may not even be aware that I have the plugs swapped until I get myself between the key and ground. I'm planning something that will keep me from accidentally removing the key plug.

Eventually I plan is to mate this transmitter with my National FB7X for a complete 1934 station that I'll use in the 2010 AWA Linc Cundall OT CW Contest.